Mounting the Remote Control

Before mounting the remote control, you must connect it to the stereo (Connecting the ARX70 Remote to a Stereo).

Select an appropriate location for the remote control (Mounting Considerations).
Thoroughly clean and dry the mounting surface using a mixture of water and isopropyl alcohol.

The mounting surface must be free of dirt, debris, wax, or coatings.
Test the range at the selected location by holding the remote at the location, pressing a few buttons, and confirming the operation on the connected stereo.
Remove the backing from the adhesive on the back of the mount.
Carefully orient the remote control and mount with the Fusion^® logo at the bottom.

NOTICE

Before placing the adhesive on the mounting surface, make sure the location and orientation are correct. It is extremely difficult to remove the adhesive. Some mounting surfaces might be damaged after removing the adhesive.
Press the remote control firmly onto the mounting surface, maintaining pressure for at least 60 seconds.
Allow the remote control to sit at room temperature for 72 hours.

TIP: To remove the remote control from the mount, gently press the remote control and rotate a quarter-turn.

ARX70