Installing the External GNSS Antenna

To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.

When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vehicle.

This antenna can be installed to provide a more accurate position from the GPS signal for your navigation device. This antenna uses a BNC connector to connect to the dock.

Using the included mounting template, mark the three pilot-hole locations and trace the cable hole in the center of the template.
Drill the three 3.2 mm (¹/₈ in.) pilot holes.
Use a 25 mm (1 in.) hole saw to cut the cable hole in the center.
Place the surface-mount bracket on the mounting surface, aligning the screw holes.
Use the included M4 screws to secure the surface-mount bracket to the mounting surface.
Place the large gasket on top of the surface-mount bracket.
Route the antenna cable through the 25 mm (1 in.) hole, and connect it to the antenna .
Place the antenna on the surface-mount bracket, and twist it clockwise to lock it in place.
Secure the antenna to the mounting bracket with the included M3 set screws .
Route the cable into the vehicle and away from sources of electronic interference.
Connect the cable to GNSS on the dock.