Skip to main content

Pairing the Remote Control

The remote control is paired with the trolling motor at the factory. Follow these steps if you need to pair it again.

  1. Turn on the trolling motor.
  2. Press on the trolling motor three times to enter pairing mode.

    The status LED on the trolling motor illuminates blue as it searches for a connection.

  3. Bring the remote control within 1 m (3 ft.) of the trolling motor.
  4. Turn on the remote control.
  5. On the remote control, select > Settings > Remote Control > Pairing > Pair > Start.

    After a few seconds, Pairing Complete is shown on the remote control.

Pairing an Additional Remote Control

You can have up to two remote controls connected to your trolling motor at the same time.

To pair a second remote control, you must follow these steps using the first connected remote control.

  1. Turn on the trolling motor.
  2. On a remote control already paired to the motor, select > Settings > Remote Control > Pairing > Add Additional Remote.
  3. Bring the additional remote control within 1 m (3 ft.) of the display panel on the trolling motor.
  4. Turn on the additional remote control.
  5. On the additional remote control, select > Settings > Remote Control > Pairing > Pair > Start.

    Device Found appears on the first remote control. After a few seconds, Pairing Complete appears on the second remote control.

GUID-A7668193-255A-4F7A-AAEC-C153FB825CB4 v2
November 2025
© 2025 Garmin Ltd.