Skip to main content

Fixed-Bail Mounting the Device

NOTICE

If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer when the screws are tightened.

  1. Select the mounting hardware appropriate for the bail-mount bracket Callout number one and your mounting surface.

    Fixed bail mount with callouts
  2. Using the bail-mount bracket as a template, mark the pilot holes through the screw holes.
  3. Using a drill bit appropriate for the mounting hardware, drill the four pilot holes.
  4. Using the selected mounting hardware Callout number two, secure the bail-mount bracket to the mounting surface.
  5. Loosely install the bail-mount knobs Callout number three.
  6. Place the device Callout number four in the bail-mount bracket.
  7. Tighten the bail-mount knobs.
Copyright © Garmin. All rights reserved.GUID-8FDBCF2B-E4C1-48B8-BFBC-D3C00EC9A832 v1