Force Kraken Trolling Motor Owner's Manual

Take a picture or count and write down the number of coils in the coil cable that wraps around the shaft.

When re-assembling the shaft and shaft cap, you must use the same number of coils around the shaft.

Using a #3 Phillips screwdriver, remove the ¹/₄-20 bolts Callout number 1

, lock washers, and nuts Callout number 2

that secure the shaft cap to the shaft.

You should keep these bolts and nuts in a safe place, because you must use them when reinstalling the shaft cap.

Lift up the shaft cap to disconnect it from the shaft.

Pull the cables completely through the shaft cap, taking care to avoid damaging the cable connectors when you pull them through.

Force® Kraken Trolling Motor