Force Kraken Trolling Motor Owner's Manual - Installing the Transducer Cable in the Shaft Cap

If previously removed, feed the transducer cable Callout number 1

completely through the square hole in the shaft cap.

Install the grommet Callout number 2

on the transducer cable.

The grommet is split on one side to make it easy to install on the cable.

Push from the outside to secure the square grommet in the shaft cap.

Route the transducer cable alongside the coil cable, using electrical tape to hold the cables together.

Route the LiveScope™ transducer cable to the sonar module or to the transducer extension cable and connect it.

Force® Kraken Trolling Motor