Installing the Release Latch
-
Apply marine grease to the release latch
.
-
Ensure the bushings
are in place on the latch as pictured, aligning the holes in the bushings with the holes in the latch.
- Slide the latch in place in the steering servo, rounded side down.
-
Place the springs
over the latch holes.
-
Place the latch cover
on the springs, lining up the holes, and insert the latch cover screws
.
- Apply light pressure to the latch cover and secure the latch cover screws using a 4 mm hex bit or wrench.
Parent Topic: Assembly Procedures