Skip to main content

Removing the LiveScope Transducer Cable from the Shaft Cap

NOTE: Not all models have a LiveScope™ transducer cable routed through the trolling motor shaft.
  1. If it is present, disconnect the transducer cable from the sonar module or from the transducer extension cable.
  2. Remove the tape securing the transducer cable to the coiled power cable.
  3. Straighten the transducer cable so you can easily pull it through the shaft cap.
  4. Push from the inside out to remove the square grommet Callout number 1 that holds the transducer cable Callout number 2 in the shaft cap.

    Device Top View with Callouts
  5. Remove the grommet from the transducer cable.

    The grommet is split on one side to make it easy to remove from the cable.

    You should keep the grommet in a safe place, because you must reinstall it later.

  6. Remove the threaded collar from the transducer cable.
  7. Feed the transducer cable through the shaft cap from the outside in until it is no longer routed through the square hole.
GUID-828BF524-69C7-4E20-A109-CE89908F9BDD v2
June 2024
© 2024 Garmin Ltd.