Skip to main content

Removing the Shaft Mini-Tumbler and Biasing Bushing with the Shaft Installed

You can remove the shaft mini-tumbler and biasing bushing from the steering servo housing while the shaft is installed.

  1. Stow the motor.
  2. Using a #2 Phillips bit or screwdriver, remove the screw Callout number 1 from the biasing bushing Callout number 2.

    Diagram with Callouts
  3. Slide the biasing bushing up and pull it off of the shaft.
  4. Deploy the motor, ensuring the weight of the motor is resting on a stable surface and not on the depth-adjustment assembly.
  5. Align the shaft mini-tumbler Callout number 3 with the lowest point of the shaft carrier.

    Diagram with Callout
  6. Using a flat-head screwdriver or similar tool, slide the shaft mini-tumbler up from the steering servo, and pull it off of the shaft.
GUID-828BF524-69C7-4E20-A109-CE89908F9BDD v2
June 2024
© 2024 Garmin Ltd.