Fastening the Swivel Mount with the Cables Running through the Mount
You should complete this procedure only when running the power and transducer cables under the mounting surface and through the swivel-mount base.
- Feed the cables through the 16 mm (5/8 in.) center hole you drilled when preparing to run cables beneath the mounting surface.
- Place the base on the mounting surface.
- Route the cables through the cable pass-through holes.
- Loosely fasten the base using the appropriate screws or bolts.
- Place the swivel mount on the base, but do not fasten it.
- Place the cradle or device into the swivel mount (Installing the Device in the Cradle).
- Pull out enough slack from the power and transducer cables so the mount can fully swivel to the desired positions when the cables are connected.
- Remove the cradle and the swivel mount from the base.
- Apply marine sealant to the 16 mm (5/8 in.) center hole and to the cable pass-through holes.
- Securely fasten the base with the appropriate screws or bolts.
- Place the swivel mount on the base, and fasten it using the included 10 mm M6×1 Phillips screw.