Skip to main content

Preparing to Run Cables under the Mounting Surface

NOTICE

Use pan-head screws or bolts when securing the swivel-mount base. Screws or bolts with countersunk heads damage the base.

Before you can prepare the swivel-mount base, you must choose the location to install the mount and decide whether to attach the mount using screws or bolts.

  1. Remove the 10 mm M6x1 Phillips screw Callout number one and separate the swivel mount Callout number two from the base Callout number three.

    Swivel base installation with callouts
  2. Orient the swivel base so the pass-through holes Callout number four face the desired direction.
  3. Using the swivel base as a template, mark the pilot hole locations Callout number five.
  4. Mark the cable routing hole Callout number six.

    Swivel base holes with callouts
  5. Using the appropriate drill bit for the hardware, drill the three pilot holes.
  6. Using a 16 mm (5/8 in.) drill bit, drill the cable-routing hole.
Copyright © Garmin. All rights reserved.GUID-760FBC47-2446-4474-B03E-DC2085C730B6 v2