Important Safety Information
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
You must install this device securely according to these instructions. Failure to install this device in accordance with these instructions could result in serious personal injury, damage to the device and/or vessel, or poor product performance.
To avoid possible serious personal injury or damage to the device and the vessel, you must disconnect the power supply to the vessel's audio system before beginning to install the device.
Continuous exposure to sound pressure levels over 100 dBA may cause permanent hearing loss. The volume is typically too loud if you cannot hear people speaking around you. Limit the amount of time you listen at high volume. If you experience ringing in your ears or muffled speech, stop listening and have your hearing checked.
The product contains magnets that may interfere with medical devices. Consult your physician and medical device manufacturer with questions.
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
The product contains magnets that may cause damage to some electronic devices. Use caution using the product near electronic devices.
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
It is strongly recommended that you have your audio system installed by a professional installer to ensure optimum performance.
You must read all installation instructions before beginning the installation. If you experience difficulty during the installation, go to support.garmin.com for product support.
Tools Needed
-
Appropriate saw or cutting tool to cut the surface material
-
Marine sealant such as 3M™ 4200 or 5200
-
4.8 mm and 6.3 mm female spade connectors
-
Torque screwdriver with a Phillips bit
-
#2 Phillips screwdriver
-
Drill and drill bits
-
Wire cutter
-
Wire strippers
-
Crimping tool
-
Speaker wire (Speaker Wire Gauge Guide)