Maintenance Needs and Schedule
After using the motor in salt water or brackish water, you must rinse off the entire motor with fresh water, and apply a water-based silicone spray using a soft cloth. You must avoid spraying jets of water at the shaft cap, to prevent water ingress that could lead to product damage.
To maintain your warranty, you must perform routine maintenance tasks to prepare your motor for the season. If you transport the motor in dry and dusty environments such as gravel or dirt roads, you should repeat these tasks during the season as needed.
For detailed maintenance and service instructions, see the Owner's Manual and the Field Service Manual on garmin.com/manuals/force_pro_trolling_motor .
-
Examine the power cable for wear, and replace it if necessary.
-
Check and clean the power terminals and tighten the nuts , if necessary.
-
Lubricate the hinges and bushings .
-
Clean and lubricate the stow and deploy latch mechanism .
-
Check the mount rails , and replace them if necessary.
-
Check the mount bumper , and replace it if necessary.
-
Clean or replace the anodes in the propeller drive motor .
-
If installed, check the rubber stops on the ends of the stabilizer for wear and replace them as necessary.
-
Examine the coil cable for wear, and replace it if necessary.
-
Examine the pull-cable and handle for wear, and replace it if necessary.