Skip to main content

Installing the Handset Cradle

You should install the handset connector in the mounting surface before installing the handset cradle (Installing the Handset Connector in the Mounting Surface ).

  1. Select a mounting location for the handset cradle near the handset connector.
    TIP: To help determine the best location, you can place the handset in the cradle, connect the handset to the connector, and hold it against the mounting surface.
  2. Using the cradle as a template, mark the screw locations.
  3. Set the cradle aside.

    Do not drill through the cradle.

  4. Using a 3 mm (1/8 in.) drill bit, drill the pilot holes.
  5. Using the included M3.5 screws, secure the cradle to the mounting surface.
Copyright © Garmin. All rights reserved.GUID-395B9869-0DCF-4E17-A266-0D9FF08A27DE v3