Graphically Add Waypoints To The End Of The En Route Section Of The Active Flight Plan:
- With a flight plan active, navigate to the map application page on the MFW.
- Momentarily, touch and hold any leg or waypoint along the Active Flight Plan. Then, release to activate Graphical Edit Mode.
- With one finger, touch and release the desired location on the map.
-
Select the desired waypoint:
If only one waypoint is located at the point that was touched on the map, that waypoint and leg to and from it shall be displayed in cyan on the map.
Or:
If no waypoints are located at the point that was touched on the map, a temporary user waypoint is created and the leg to and from it shall be displayed in cyan on the map.
Or:
If multiple waypoints are located near the point that was touched on the map, the 'Nearest Items' Window is displayed, listing all waypoints near the touch point. Touch the button for the desired waypoint. That waypoint and the new leg to and from it shall be displayed in cyan on the map.
- If necessary, touch the Undo Button to undo the most recent change made before continuing in Graphical Edit Mode.
- If adding multiple waypoints, repeat Steps 3 through 5 until all desired changes are complete.
-
Touch the Activate Button to
apply all changes to the active flight plan and exit Graphical Edit Mode.
Or:
Touch the Cancel Edit Button then touch the OK Button to remove all changes and exit Graphical Edit Mode.