Skip to main content

Graphically Create A Parallel Offset In The Active Flight Plan:

  1. With a flight plan active, navigate to the map application page on the MFW.
  2. Activate Graphical Edit Mode:

    Momentarily, touch and hold one finger on any leg or waypoint along the Active Flight Plan. Then, release to activate Graphical Edit Mode.

    Or:

    Touch the any waypoint along the Active Flight Plan. Then, touch the Graphical Reroute Button on the Radial Menu to activate Graphical Edit Mode.

  3. Touch and hold two fingers this time, on a leg along the Active Flight Plan, and continue holding, while dragging fingers perpendicular to the leg until the necessary offset distance is displayed in the Map Data Box.
  4. Remove fingers from the map. The 'Parallel Offset' Window is displayed, pre-filled with the graphical parallel offset distance from the aircraft present position to the last enroute or arrival waypoint.
  5. To edit any of the pre-filled settings, use the keypad to change the distance, or touch the Start At Datafield Button or the button for the end offset waypoint and select the desired waypoints.
  6. Touch the Load Button. The parallel offset is displayed in cyan on the map and offset waypoints are created in the flight plan.
  7. Touch the Activate Button to apply all changes to the active flight plan and exit Graphical Edit Mode.

    Or:

    Touch the Cancel Edit Button then touch the OK Button to remove all changes and exit Graphical Edit Mode.

190-03123-21 Rev A
July 2026
© 2026 Garmin Ltd.