Skip to main content

Installing the NEO Motion Plates

You can use the NEO Motion Plates accessory with any Tacx ® NEO trainer.

  1. Remove the 4 feet from the Tacx NEO trainer.

    Trainer with plastic feet removed
  2. Store the feet on the NEO Motion Plates.

    Device with plastic feet storage
  3. Lift the left side of the Tacx NEO trainer, and align the left plate.

    Trainer with left plate aligned
  4. Lift the right side of the Tacx NEO trainer, and align the right plate.

    Trainer with right plate aligned
  5. Check the alignment of the plates on both sides.

    You may need to lift and adjust each side to align the plates correctly.

    NOTE: Both plates must be fully seated.

    Device alignment details
Copyright © Garmin. All rights reserved.GUID-125ECACD-A830-4FBE-A3A9-BAFC456035DD v1