Dive Setup

You can customize the dive settings based on your needs. Not all settings are applicable for all dive modes. You can also edit the settings before you start a dive.

Select Dive Setup.

Gases: Sets the gas blends used in the gas dive modes (Setting Up Your Breathing Gases). You can have up to twelve gases for each gas dive mode.

Dive Network & Air Integration: Pairs Descent transceivers and configures the data screens (Air Integration).

Conservatism: Sets the level of conservatism for decompression calculations. Higher conservatism provides a shorter bottom time and a longer ascent time. The Custom option sets a custom gradient factor.

NOTE: Make sure you understand gradient factors before entering a custom level of conservatism.

Water Type: Sets the water type.

PO2: Sets the partial pressure of oxygen (PO2) thresholds, in bar, for the maximum operating depth (MOD), decompression, warnings, and critical alerts (Setting PO2 Thresholds).

Scuba Alerts: Sets custom alerts for gas dives (Setting a Custom Dive Alert).

Display Settings: Customizes the data screens for each dive mode (Dive Data Screens).

Safety Stop: Changes the safety stop duration.

Last Deco Stop: Sets the depth of the final decompression stop.

End Dive Delay: Sets the length of time before the device ends and saves a dive after surfacing.

CCR Setpoints: Sets high and low PO2 setpoints for closed-circuit rebreather (CCR) dives (Setting CCR Setpoints).

Dive Shortcuts: Assigns button shortcuts for use during dives.

Advanced Settings: Customizes advanced dive mode settings (Dive Mode Advanced Settings).