Skip to main content

Starting a Trap Shooting Session

  1. Position the device directly in front of you at your shooting station.

    Overhead view of the correct position of the device relative to the user
  2. Stand directly behind the Xero® S1 device with your front foot no more than 46 cm (18 in.) away from it.
  3. Select TRAP MODE.
  4. Select a trap game mode (Trap Game Modes).
  5. If necessary, select a data field to change information about your shooting session.
    TIP: Information entered on the setup screen is used to calibrate the device for your shooting session. You should verify all information is accurate.
  6. Select Check mark icon.
  7. Select your current shooting station, and select Check mark icon.
  8. Align the device so the point of the arrow Callout number one is centered above the trap house Callout number two.

    Trap house aligned using on-screen arrow with callouts
    NOTE: The arrow and trap house could appear in different positions depending on your shooting station. You should verify the top of the alignment window is aligned with the top edge of the trap house.
  9. Select Check mark icon.
  10. When the READY notification appears, begin your shooting session.
    NOTE: The device will not detect a shot until the READY notification is on the screen. You should always confirm the device is ready before taking a shot.

After five shots, you are prompted to change shooting stations. Follow the on-screen instructions to set up your device at a different shooting station.

Copyright © Garmin. All rights reserved.GUID-8042F2C8-C319-4963-A692-B42C26A10936 v3