Replacing the Battery

WARNING

Do not use a sharp object to remove batteries.

WARNING

Keep the battery away from children.

WARNING

Never put batteries in mouth. If swallowed, contact your physician or local poison control center.

WARNING

Replaceable coin cell batteries may contain perchlorate material. Special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.

CAUTION

Contact your local waste disposal department to properly recycle the batteries.

Before you can replace the battery, you must remove the silicone clip.

  1. Locate the circular battery cover Callout number one on the back of the sensor.

    Battery installation with callouts
  2. Twist the cover counter-clockwise until it is loose enough to remove.
  3. Remove the cover and the battery Callout number two.
    TIP: You can use a piece of tape Callout number three or a magnet to remove the battery from the cover.
    Battery removal with a callout
  4. Wait 30 seconds.
  5. Insert the new battery into the cover, observing polarity.
    NOTE: Do not damage or lose the O-ring gasket.
  6. Replace the cover by aligning the dots and rotating clockwise.
    TIP: To confirm proper battery replacement, tap the device until the LEDs flash.
Copyright © Garmin. All rights reserved.GUID-673356BC-0927-4C7A-BB57-059DD433850E v4