Skip to main content

Replacing a Cover Lens

If either of the cover lenses become scratched or damaged, you can replace them. The VIRB® 360 lens replacement kit includes two cover lenses, two gaskets, and two lens retainer rings. Go to garmin.com/virb to purchase a lens replacement kit.

  1. Turn the lens retainer ring counter-clockwise to unlock it.

    Front view of camera with arrow
  2. Remove the lens retainer ring, cover lens Callout number one, and gasket Callout number two.

    Exploded view of camera lens assembly with callouts
  3. Wipe the gasket groove Callout number three with a lint-free cloth.
  4. Verify the new cover lens, new gasket, and the gasket groove are clean and free of dust or debris.
    NOTICE

    The camera may not be water resistant if the gasket and sealing surface are not clean and free of dust or debris. Dust or debris may damage the gasket or prevent the gasket from sealing properly.

  5. Place the new gasket, cover lens, and lens retainer ring on the camera.
  6. Rotate the lens retainer ring clockwise until the marks Callout number four on the camera and the lens retainer ring are aligned.
    NOTICE

    The camera is not water resistant when the lens retainer ring is not fully tightened.


    Front view of camera with arrow and callout
Copyright © Garmin. All rights reserved.GUID-7C8599D3-48DE-4599-9EB4-B6217680D3A2 v5