You can change the settings for the dock access point.

While the remote is docked, select Settings > Wi-Fi > RV HUB DOCK, and set the mode switch at the top of the screen to Access Point.

SSID

Allows you to change the network name for the access point.

PSK

Sets the password for the access point. This field is required if the Security setting is set to a value other than None.

Security

Sets the security mode for the access point. If the security mode is set to None, a password is not required to connect to the dock.

Advanced

Allows you to set the country in which the access point is operating and change the Wi-Fi channel the network uses. Depending on your environment, changing to a less congested channel can help to improve the quality of your connection.

DHCP

Allows you to set the start and end of the IP address range used by the internal DHCP server, or disable the DHCP server.

NOTE: You should not change the DHCP settings unless it is required for the local network and you have a thorough knowledge of the local network configuration. Incorrect DHCP settings can prevent the remote from connecting to the dock. If the DHCP server is disabled, you must provide a separate DHCP server or manually configure IP addresses for all connected devices. If you have changed the DHCP settings and the remote cannot connect to the dock, you should reset the Wi-Fi settings to their factory default values.