Skip to main content

Mounting and Powering the Device in an Automobile

WARNING

This product contains a lithium-ion battery. To prevent the possibility of personal injury or product damage caused by battery exposure to extreme heat, store the device out of direct sunlight.

WARNING

Both the device and its mount contain magnets. Under certain circumstances, magnets may cause interference with some internal medical devices, including pacemakers and insulin pumps. Keep the device and its mount away from such medical devices.

NOTICE

Both the device and its mount contain magnets. Under certain circumstances, magnets may cause damage to some electronic devices, including hard drives in laptop computers. Use caution when the device or its mount is near electronic devices.

The RV HUB remote can operate independently as a full-featured navigation device. You can use an optional automobile mount accessory to mount the remote in another vehicle. This is useful when your RV is parked and you are using an automobile to travel locally. Go to buy.garmin.com to purchase accessories.

  1. Plug the vehicle power cable Callout number one into the USB port on the automobile mount.

    Device connecting to the mount and power with callouts
  2. Press the mount Callout number two onto the suction cup Callout number three until it snaps into place.

    The Garmin® logo on the mount should face right-side up.

  3. Press the suction cup to the windshield, and flip the lever Callout number four back toward the windshield.
  4. Place the back of the device onto the magnetic mount.
  5. Plug the other end of the vehicle power cable into a power outlet in your vehicle.
  6. Switch the RV HUB remote to the Car vehicle profile (Vehicle Profiles).
Copyright © Garmin. All rights reserved.GUID-0E9D9439-6B91-4B50-8492-83D80CC16653 v4