Calibrating the Compass

Before you can calibrate the compass, the transducer must be installed far enough away from the trolling motor to avoid magnetic interference, and deployed in the water. Calibration must be of sufficient quality to enable the internal compass.

NOTE: Compass calibration is available only for transducers with an internal compass.

You can begin turning your boat before calibrating, but you must fully rotate your boat 1.5 times during calibration.

  1. From the LiveVü Forward sonar page, select Menu > Sonar Setup > Installation.
  2. If necessary, select Use AHRS.
  3. Select Calibrate Compass.
  4. Follow the on-screen instructions.
Copyright © Garmin. All rights reserved.GUID-871A9CBC-B2B9-4771-BF1A-58BB3DB7060F v11