From a sonar view, select MENU > Sonar Setup > Installation.

Restore Sonar Defaults

Restores the factory default settings for the sonar view.

Transducer Type

Allows you to select the type of transducer that is connected to the device.

Shift

Allows you to set the depth range on which the sonar is focused. This enables you to zoom in to an area within the focused depth.

Flip Left/Right

Changes the orientation of the SideVü sonar view when the transducer is installed backward.

Flipped

Sets the orientation of the Panoptix™ sonar view when the transducer is installed with the cables pointing toward the port side of the boat.

Beam Width

Sets the width of the Panoptix transducer beam.

Narrow beam widths allow you to see deeper and farther. Wider beam widths allow you to see more coverage area.

Use AHRS

Allows the internal attitude heading and reference system (AHRS) sensors to detect the installation angle of the Panoptix transducer. When this setting is turned off, it is assumed the transducer is installed at a 45-degree angle.