Replacing the Adhesive on the Mount

You can replace the adhesive disc on the mount to install the device in a new location. Your device includes one extra adhesive mount. Go to https://buy.garmin.com to purchase additional adhesive mount.

  1. If necessary, remove the adhesive from the mount.
  2. Clean the mount.

    The mount must be free of dust, wax, oils, or coatings.

  3. Remove one side of the protective film from the mount adhesive.
  4. Position the adhesive over the mount.
    TIP: The adhesive is extremely sticky. Do not touch the adhesive to the mount until the adhesive is properly aligned.
  5. Press the adhesive firmly onto the mount, and maintain pressure for 30 seconds.
  6. Install the camera mount onto your windshield (Installing the Mount onto Your Windshield).
Copyright © Garmin. All rights reserved.GUID-F79C150D-E3E2-493F-9338-23C27A020612 v2