Setting the Fusion PartyBus Device as a Wireless Access Point

Before you can connect additional Fusion PartyBus™ devices or smartphones to a Fusion PartyBus device wirelessly, you must configure at least one device as a wireless access point. This is not necessary if you installed a wireless router or other wireless access point on the network.

Select > > > > Network > WI-FI ACCESS POINT.
Select SSID and change the default SSID, or name, for the wireless access point (optional).
Select AP Security: %1 and change the security type for the access point (optional).

NOTE: It is strongly recommended that you use the default WPA2 Personal AP Security: %1 setting. It is the most widely used and secure wireless security protocol.
Select Password and change the default password for the access point (optional).
If necessary, select Country: %1 and select your region.
Select Channel: %1 and select a channel range for the access point (optional).
Select Save.

You can adjust the wireless access point configuration at any time (Wireless Access Point Settings).

Vieo™ RV 850 / RV 1050 Series

Previous Topic

Next Topic

Download PDF

Print Page

Setting the Fusion PartyBus Device as a Wireless Access Point