Important Safety Information
Failure to follow these warnings, cautions, and notices could result in personal injury, damage to the vessel or device, or poor product performance.
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
To avoid possible personal injury or damage to the device and vessel, disconnect the vessel's power supply before beginning to install the device.
To avoid possible personal injury or damage to the device or vessel, before applying power to the device, make sure that it has been properly grounded, following the instructions in the guide.
For the best possible performance, the device must be installed according to these instructions.
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
Tools Needed
-
Drill and drill bits
-
Needed for flush mounting:
2 mm (5/64 in.) bit
11.2 mm (7/16 in.)
-
Needed for surface mounting:
2 mm (5/64 in.) bit
20 mm (13/16 in.) bit
-
-
#2 Phillips screwdriver
-
Jigsaw or rotary tool (for flush mounting)
-
File and sandpaper
-
Marine sealant (recommended)
Software Update
After you install this device, you must update the software for all autopilot components, connected Garmin® chartplotters, and other connected devices. For instructions on updating the software, see the owner's manual for your chartplotter or helm control device at garmin.com/manuals.