Removing the Electronics Box

The high voltage capacitors in this product can hold a charge well after disconnecting power. While servicing the unit, take all necessary precautions against high voltage. High voltage electrocution can result in serious personal injury or death.

Cut the cable tie that secures the internal network cable, the internal power cable, and the LNC coaxial cable to the boss supporting the left side of the electronics box.
Pinch the internal power cable connector to release the latch, and disconnect it from the electronics box.
Using a flat screwdriver, lift the retaining latch on the under side of the internal network connector, and disconnect it from the electronics box.

NOTE: The internal network cable connector is a standard water-resistant RJ45 connector.
Disconnect all remaining cables on the front of the electronics box by pulling their connectors away from the electronics box.
Remove the four screws securing the electronics box to the pedestal housing.
Slide the electronics box partly out of the housing.
Pull the motor cable connector up with moderate force to disconnect it from the electronics box.
Disconnect the status indicator light cable and the antenna position sensor board ribbon cable from the motor control board on top of the electronics box.

GMR™ xHD3

Previous Topic

Next Topic

Download PDF

Print Page

Removing the Electronics Box