Bail Mounting the Device
If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid any cracking in the gel-coat layer when the screws are tightened.
Stainless-steel screws may bind when screwed into fiberglass and overtightened. Garmin® recommends applying an anti-seize lubricant to the screws before installing them.
You can use the included bracket to bail mount the device on a flat surface.
-
Using the bail-mount bracket
as a template, mark the pilot holes 
.
-
Using the included screws
, secure the bail-mount bracket to the mounting surface.
-
Install the bail-mount knobs
on the sides of the device.