NMEA 2000 Considerations

NOTICE

If you are connecting to an existing NMEA 2000® network, identify the NMEA 2000 power cable. Only one NMEA 2000 power cable is required for the NMEA 2000 network to operate properly.

A NMEA 2000 Power Isolator (010-11580-00) should be used in installations where the existing NMEA 2000 network manufacturer is unknown.

NOTICE

If you are installing a NMEA 2000 power cable, you must connect it to the boat ignition switch or through another in-line switch. NMEA 2000 devices will drain your battery if the NMEA 2000 power cable is connected to the battery directly.

You can connect your device to a NMEA 2000 network on your boat to share data from NMEA 2000 compatible devices such as sensors or a VHF radio. The necessary NMEA 2000 cables and connectors are sold separately.

If you are unfamiliar with NMEA 2000, you should read the “NMEA 2000 Network Fundamentals” chapter of the Technical Reference for NMEA 2000 Products. You can find this document using the "Manuals" link on the product page for your device at garmin.com.

The port labeled NMEA 2000 on the cradle is used to connect it to a standard NMEA 2000 network.


Wiring diagram with callouts

Item

Description

Callout number one

ECHOMAP™ UHD device

Callout number two

NMEA 2000 drop cable

Callout number three

NMEA 2000 power cable

Callout number four

Ignition or in-line switch

Callout number five

12 Vdc power source

Callout number six

NMEA 2000 terminator or backbone cable

Callout number seven

NMEA 2000 T-connector

Callout number eight

NMEA 2000 terminator or backbone cable

Copyright © Garmin. All rights reserved.GUID-D4F04D40-7D5A-4040-AD3F-27506E0DAFD0 v3