Setting the Spy Pole Mount Depth

You can use the depth-indicator ring to set the maximum depth for the Spy Pole™ mount. With the depth-indicator ring in place, you can raise the Spy Pole™ shaft if needed, and the ring will prevent it from lowering too deep when returning it back to the set position.

NOTICE

If you installed the Spy Pole™ mount on a trolling motor, you must set the depth-indicator ring so that any attachments at the bottom of the Spy Pole™ mount are at least 25 mm (1 in.) away from the trolling motor propeller. If the trolling motor propeller contacts the Spy Pole™ mount, it can damage it, any attachments on the shaft, and the propeller.

  1. If the Spy Pole™ mount is installed on a trolling motor, partially deploy the motor while your vessel is out of the water so you can observe the distance from the bottom of the pole to the trolling motor propeller.
  2. Using a #2 Phillips screwdriver, loosen the screw in the depth ring 1 until it slides freely along the Spy Pole™ shaft.

    The depth indicator ring sliding onto the top of the Spy Pole Mount
  3. Loosen the depth adjustment collar 2 on top of the Spy Pole™ mount motor housing 3 and adjust the depth of the pole.
  4. If you installed the Spy Pole™ mount on a trolling motor, test the depth to make sure that the trolling motor propeller does not contact the Spy Pole™ mount or any attachments on the pole and make any adjustments as needed.
  5. After the pole is set at the preferred depth, tighten the depth-adjustment collar.
  6. Slide the depth ring down until it sits flush against the top of the depth-adjustment collar.
  7. Tighten the screw on the depth ring to secure it in place.
The depth ring marks the Spy Pole™ mount's maximum depth and prevents it from being lowered deeper. If you raise the pole out of the water, you can easily return it to your preferred depth by sliding it down until it contacts the depth ring.
GUID-CE86F073-380E-435D-8743-D823C364C077 v2
October 2026