Installing the Spy Pole Foot Control

You can control the Spy Pole™ mount using the Spy Pole™ foot control.

  1. Identify a surface on your vessel where there is room to install the foot control.
    NOTE: You need to allow at least 16 mm of clearance on the upward side of the foot control to leave room for installation on the mounting plate.
  2. Use the foot control mounting plate as a template to mark the pilot holes at the mounting location.
  3. Remove the mounting plate and drill the marked pilot holes.
    NOTICE

    You should not drill through the mounting plate. Drilling through the mounting plate may result in damage.

  4. Use the two included M4.2 x 16 mm screws to secure the mounting plate to your vessel.
  5. Open the battery door on the bottom of the foot control and install two AA batteries.
  6. Close the battery door.
  7. Set the foot control down over the mounting plate and push it upwards to secure it on the mounting plate.
    You will hear a click when the foot control is secured to the mounting plate.
GUID-CE86F073-380E-435D-8743-D823C364C077 v2
October 2026