Selecting a Zone
On compatible stereos, you can use the ARX70 remote control to select a zone and change the volume of the zone. Some stereos require a software update to enable this functionality of the remote.
NOTE:
When you connect to a stereo, all zones are selected by default.
-
Press
and
to enter zone selection mode.
The status LED begins flashing green.
-
Press a button to make a selection:
-
Press
for zone 1.
-
Press
for zone 2.
-
Press
for zone 3.
-
Press
for zone 4.
-
Press
for all zones.
-
Press
to cancel the zone selection.
When a zone is selected successfully, the status LED turns on green briefly and then turns off. When zone selection fails, times out, or is canceled, the status LED turns on red briefly and then turns off.
-
NOTE:
When you select an inactive or invalid zone, the remote still functions but does not control the volume. You can select
to select all zones.
to select all zones.