Installing the Varia RDU Device

NOTE: If you do not have a Varia™ RDU device, you can use a compatible Edge® device.

You can install the device on the stem or the handlebars.

  1. Select a secure location to mount the device where it does not interfere with the safe operation of your bike.
  2. Place the rubber disk Callout number one on the back of the bike mount.

    The rubber tabs align with the back of the bike mount so it stays in place.


    Mount on the handlebars with callouts
  3. Place the bike mount on the bike stem.
  4. Attach the bike mount securely using the two bands Callout number two.
  5. Align the tabs on the back of the device with the bike mount notches Callout number three.
  6. Press down slightly and turn the device clockwise until it locks into place.

    Device mounted on the handlebars
Copyright © Garmin. All rights reserved.GUID-C41F445D-457F-447D-88C8-FE286BF157E9 v3