Garmin BlueNet Network with GC 200 Camera Using a Power Module
-
You can connect the power module from the camera to either a Garmin BlueNet chartplotter or a Garmin BlueNet 20 switch using an using an adapter cable (010-13094-00).
-
You can connect the power module from the camera directly to a legacy Garmin Marine Network chartplotter or a GMS™ 10 switch.
Some jurisdictions may prohibit or regulate recording audio and video, or taking photographs. Jurisdictions may require that all parties have knowledge of the recording and provide consent before you record audio and video or take photographs. It is your responsibility to know and comply with all laws, regulations, and any other restrictions in your jurisdiction.
|
Item |
Description |
Notes |
|---|---|---|
|
|
Garmin BlueNet network devices |
All Garmin BlueNet network devices must connect to one another or to a Garmin BlueNet 20 switch. |
|
|
Legacy Garmin Marine Network devices |
If you have more than two legacy Garmin Marine Network devices, these devices must connect to one another or to a GMS 10 switch. If you have only two legacy Garmin Marine Network devices, you can connect them both to the Garmin BlueNet 30 gateway without first connecting them to one another. |
|
|
GC 200 camera power module connection |
If your Garmin BlueNet network includes at least one legacy Garmin Marine Network chartplotter, you can connect the power module for your GC 200 camera to either a Garmin BlueNet device or a legacy Garmin Marine Network depending on what is easiest to implement in your network. NOTE:
You must connect a
GC 200 camera to either legacy
Garmin Marine Network devices or to
Garmin BlueNet devices. You cannot connect a single camera directly to both types of devices.
|
|
Item |
Description |
Notes |
|---|---|---|
|
|
Garmin BlueNet 30 gateway |
|
|
|
Garmin BlueNet radar |
|
|
|
GC 200 camera |
|
|
|
Legacy Garmin Marine Network chartplotter or other device |
|
|
|
Garmin BlueNet network cable |
|
|
|
GC 200 camera power wires |
If you are using a power module to connect the camera to a 24 Vdc system, you must not connect the power wires from the camera harness. Only the power module should connect to a power source. Connecting the wires from the camera harness to a 24 Vdc system without using a power module will damage the camera. |
|
|
Power source |
Although not illustrated in this diagram, all devices must connect to power according to the installation instructions provided with the device. |
|
|
Garmin BlueNet chartplotter |
|
|
|
Power module power wires |
You must connect the power module for the GC 200 camera to a 12 to 24 Vdc power source. |
|
|
GMS 10 switch or legacy Garmin Marine Network chartplotter |
|
|
|
Legacy Garmin Marine Network cable |
|
|
|
Legacy Garmin Marine Network to Garmin BlueNet adapter cable (010-13094-00) |
