Each tube on the Spy™ pole gunnel mount includes a quick-release lever that allows you to easily adjust
the position of the mount without using tools.
-
Locate the quick-release levers, the
washers, and the end caps.
-
On the tube connector, identify the
installation hole beneath the horizontal tube.
-
Slide the lever through one washer and
into the hole in the tube connector.
NOTE: Orient the washers so that the flat sides are facing the tube
connector.
-
Place the other washer and the end cap
on the other side of the lever and screw on the end cap.
-
Tighten the cap to hold the lever in
place.
-
Repeat these steps for the vertical
tube.
You can latch the levers to hold the tubes in place, and unlatch
them to adjust them as needed.
