Bail Mounting the Device
If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer when the screws are tightened.
You can use the bracket to bail mount the device on a flat surface.
-
Using the bail-mount bracket
as a template, mark the pilot holes 
.
-
Secure the bail-mount bracket to the surface using the included washers and wood screws
.
-
Install the bail-mount knobs
on the sides of the device.