If you plan to drill a hole or need to route the cable through a tight space during installation, you can remove the existing solid locking collar on the cable before routing it. After routing the cable to the final location, you can install the included split locking collar before making the connection.
-
Use side-cutting pliers to cut through the existing solid collar.
NOTE:
Take care when cutting the existing collar to avoid damaging the cable or the connector.
-
Remove the solid collar from the cable connector and save the existing o-ring if it is not damaged.
-
Route the cable to the connection location.
-
If needed, separate the two pieces of the optional split collar.
-
Snap the pieces together around the cable connector.
-
Insert either the original o-ring or the included replacement o-ring around the connector and into the collar.