Bail Mounting a Device with a Swivel Base

NOTICE

If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer when the screws are tightened.

You can install the optional swivel base (included) on the bail mount, so you can turn the device for a wider range of viewing angles.

NOTE: The swivel base is not available for ECHOMAP™ UHD2 9 sv models.
  1. If you do not want to use the included wood screws to secure the swivel base, select the mounting hardware appropriate for the swivel base and your mounting surface.
    NOTICE

    Only pan-head machine bolts or self-tapping screws should be used to secure the swivel base. If you use screws with countersunk heads, you may damage the mounting bracket.

  2. Using the swivel base Callout number 1 as a template, mark the pilot holes Callout number 2 through the outer three screw holes.

    Swivel mount with callouts
  3. Complete an action:
    • If you are using the included wood screws, drill the three pilot holes using a 3 mm (1/8 in.) drill bit.

    • If you are using your own mounting hardware, drill the three pilot holes using a drill bit appropriate for your hardware.

  4. Press the hex end of the lock nut Callout number 3 into the center recess on the underside of the swivel base.

    The dome end of the lock nut must face the mounting surface.

  5. Align the outer three screw holes in the swivel base with the pilot holes.
  6. Secure the swivel base to the mounting surface using the included wood screws Callout number 4 or your mounting hardware.
  7. Place the bail-mount bracket Callout number 5 on the swivel base.
  8. Insert the swivel-mount bolt Callout number 6 through the center hole in the bail mount.
  9. Tighten the swivel-mount bolt with a #2 Phillips screwdriver to securely assemble the bail-mount bracket, swivel base, and lock nut.

    Do not over-tighten.

  10. Loosely install the bail-mount knobs on the sides of the cradle.
  11. Place the cradle in the bail-mount bracket.
  12. Tighten the bail-mount knobs.
GUID-B4327979-40C0-487D-8117-A36D7AD0FA51 v2
August 2023