Pairing the Remote Control
The remote control is paired with the trolling motor at the factory. Follow these steps if you need to pair it again.
-
Press
on the trolling motor three times to enter pairing mode.
The
status LED on the trolling motor illuminates blue as it searches for a connection.
-
On the remote control, select
> Settings > Remote Control > Pairing > Pair > Start.
After a few seconds, Pairing Complete is shown on the remote control.
Pairing an Additional Remote Control
You can have up to two remote controls connected to your trolling motor at the same time.
To pair a second remote control, you must follow these steps using the first connected remote control.
-
On a remote control already paired to the motor, select
> Settings > Remote Control > Pairing > Add Additional Remote.
-
On the additional remote control, select
> Settings > Remote Control > Pairing > Pair > Start.
Device Found appears on the first remote control. After a few seconds, Pairing Complete appears on the second remote control.