Skip to main content

Connecting a LiveScope LVS32 Transducer to the Side Shaft Mount

Before you connect a LiveScope™ transducer to the side shaft mount, you should route the transducer cables through the Spy Pole™ shaft. See the installation instructions for your Spy Pole™ mount at garmin.com/manuals/spypole for more information.

The GT360UHD transducer kit includes hardware that allows you to easily attach a LiveScope LVS32 transducer to the side shaft mount.

  1. Using a flat pry tool, peel off the lock nut and housing from the end of the mounting bracket on the side shaft mount.

    Installing an LVS32 transducer on the side shaft mount
  2. Select the appropriate adapter disc and screw for your LiveScope transducer model.
    Each disc is labeled with the LiveScope transducer model number.
  3. Remove the plastic coating on the back of the adapter disc, and attach it to the end flange on the side shaft mount.
  4. Slide the washer onto the screw.
  5. Feed the screw through the shaft mount and into the LiveScope transducer.
  6. Adjust the angle of the transducer, and tighten the screw using the included 5 mm hex wrench.
GUID-B39D1AB5-61FE-403B-95A5-906303C23F1E v2
October 2026
© 2026 Garmin Ltd.