Skip to main content

Installing the GT360UHD Transducer on the Spy Pole Mount

The GT360UHD transducer is installed at the factory in a mounting bracket designed to attach to the bottom shaft of the Spy Pole™ mount.

For more information about routing the GT360UHD transducer cable through the Spy Pole™ shaft, refer to the Spy Pole™ mount installation instructions at garmin.com/manuals/spypole

  1. If you have any attachments already connected to the bottom shaft of the Spy Pole™ mount, remove them.
  2. Using a #2 Phillips screwdriver, remove the top half of the Spy Pole™ shaft cap.
  3. Feed the GT360UHD transducer cable up the Spy Pole™ mount and out the top.
  4. Feed the GT360UHD transducer cable into the cable sleeve and out the other hole in the shaft cap.
  5. Slide the GT360UHD transducer assembly onto the bottom shaft.
  6. Insert the included 20 mm bolt through the holes in the GT360UHD assembly and the bottom shaft, and hand tighten the nut onto the bolt on the other side.

    Attaching the transducer to the Spy Pole
  7. Use a 5 mm hex wrench or bit to fully tighten the bolt.
GUID-B39D1AB5-61FE-403B-95A5-906303C23F1E v2
October 2026
© 2026 Garmin Ltd.