Skip to main content

Connecting a LiveScope Transducer to the Side Shaft Mount

Before you connect a LiveScope™ transducer to the side shaft mount, you should route the transducer cables through the Spy Pole™ shaft. See the installation instructions for the Spy Pole™ mount at garmin.com/manuals/spypole for more information.

The GT360UHD kit includes hardware that allows you to easily attach a LiveScope transducer to the side shaft mount. To install a LiveScopeLVS32, see the next section.

CAUTION
Do not install more than two transducers on the Spy Pole™ mount. Exceeding this limit may cause premature wear or damage and will void the product warranty.
  1. Select the appropriate adapter disc and knob for your LiveScope transducer model.
    Each disc is labeled with the LiveScope transducer model number.
    NOTE: If you are using the LiveScope transducer side shaft mount on a Spy Pole™ shaft that is installed on a trolling motor, you cannot mount a LiveScope LVS62 transducer using this mount. In this situation, you should mount the LiveScope LVS62 transducer to the bottom of the Spy Pole™ shaft.
  2. Remove the plastic coating on the back of the adapter disc, and attach it to the end flange on the side shaft mount.
  3. Feed the adapter knob through the transducer.
  4. Hand-tighten the adapter knob into the side shaft mount until the LiveScope transducer is tight against the adapter disc.

    Side shaft mount installed on a Force trolling motor
To change the angle of the transducer, loosen the knob, adjust the angle, and then tighten the knob again to secure it.
GUID-B39D1AB5-61FE-403B-95A5-906303C23F1E v2
October 2026
© 2026 Garmin Ltd.