The dogbone stabilizer provides another connection point between the trolling motor shaft and
Spy Pole™ mount to reinforce the stability of the Spy Pole™ mount when multiple devices are attached.
-
Locate the front and back half of the
trolling motor locking collar, as well as the hex screws to connect the halves.
The collar is labeled Trolling Motor.
-
Hold the halves together around the trolling motor shaft.
-
Using the included bolts, secure the two
halves together around the trolling motor shaft, and tighten them using the included 3 mm
hex wrench.
-
Locate the front and back half of the
Spy Pole™ locking collar.
The collar is labeled Spy Pole.
-
Hold the halves together around the Spy Pole™ shaft at the same height as the other collar.
-
Using the included bolts, secure the
halves together around the Spy Pole™ shaft, and tighten them using the included 3 mm hex wrench.
-
Unlatch each end of the dogbone stabilizer.
-
Place the dogbone stabilizer around both
collars, and latch the clasps.
