Calibrating the Compass
Before you can calibrate the compass, the transducer must be installed far enough away from the trolling motor to avoid magnetic interference, and deployed in the water. Calibration must be of sufficient quality to enable the internal compass.
The compass may not work if you mount the transducer on the motor.
NOTE:
For best results, you should use a heading sensor such as the
SteadyCast™ heading sensor. The heading sensor shows the direction the transducer is pointing relative to the boat.
You can begin turning your boat before calibrating, but you must fully rotate your boat 1.5 times during calibration.
- From an applicable sonar view, select .
- Follow the on-screen instructions.
NOTE:
If you change the transducer orientation, you may need to recalibrate the
compass.