Skip to main content

Replacing the Dog Collar VHF Antenna

Before you replace the VHF antenna, you must remove all dirt, water, and debris from the dog collar device. You must also have a small Phillips (#2) screwdriver.

  1. Remove the 2 screws Callout number one from the cover over the VHF antenna.

    Removing the dog collar antenna cover with callouts
  2. Remove the VHF antenna cover.
  3. Remove the screw Callout number two securing the VHF antenna to the back plate.
  4. Pull the length of the antenna from the antenna guide to remove the old antenna.
  5. Thread the new VHF antenna through the antenna guide.
  6. Replace the screw securing the VHF antenna to the back plate.
  7. Replace the cover over the VHF antenna.
  8. Replace and tighten the 2 screws securing the VHF antenna cover.
  9. Secure the antenna with additional antenna clips (optional).

    Using the antenna clips
Copyright © Garmin. All rights reserved.GUID-992E9C90-AE40-4ED4-B3C4-9D812BD4DF89 v1