Skip to main content

Connecting the Device to Power

WARNING

When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product warranty.

NOTE: Disregard the blue and brown wires on the wiring harness.
  1. Route the power cable between the power source and the device.
  2. Connect the red wire from the wiring harness to the positive (+) battery terminal.
  3. Connect the black wire from the wiring harness to your boat's common ground or to the negative (-) battery terminal if no common ground is available.
  4. Align the divot on the power cable connector with the keying on the POWER port on the back of the device.
    NOTICE

    You must align the holes on the cable connector with the pins in the cable port. Misalignment of the cable connection could damage the device.

  5. Push the connector firmly into the port until fully seated.

If the device behaves erratically, the cable connector may not be fully seated. Disconnect the cable connector from the port, check the pin alignment, and firmly push the connector into the port.

Copyright © Garmin. All rights reserved.GUID-8FDBCF2B-E4C1-48B8-BFBC-D3C00EC9A832 v1