Skip to main content

Bail Mounting the Device

NOTICE

If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer when the screws are tightened.

You can use the bracket to bail mount the device on a flat surface.The bail-mount bracket and hardware are included in 8x10 and 8x12 models. The bail mount is available for purchase as an accessory for the 8x16 models.

  1. Using the bail-mount bracket Callout number one as a template, mark the pilot holes Callout number two.

    Device bail-mount installation with callouts
  2. Using a 3 mm (1/8 in.) drill bit, drill the pilot holes.
  3. Secure the bail-mount bracket to the surface using the included washers and wood screws Callout number three.
  4. Install the bail-mount knobs Callout number four on the sides of the device.
  5. Place the device in the bail-mount bracket, and tighten the bail-mount knobs.
  6. Install the trim caps by snapping them in place around the edges of the device.
Copyright © Garmin. All rights reserved.GUID-871DF8A0-D7F0-41CD-BC39-FB7822E19BFB v3