Skip to main content

Connecting Vehicle and Backup Cameras

You can connect up to four analog vehicle cameras to the infotainment system for backup, left, right, and front cameras.

  1. For each camera, route the camera's RCA analog video cable to the back of the stereo.

    You should clearly label each cable for reference when you are connecting them to the stereo.

  2. For each camera, determine the analog high signal that should trigger the stereo to display the camera, and route a wire for that signal to the back of the stereo.

    For example, you can use a reverse signal to trigger the backup camera when the vehicle is put in reverse, or you can use turn signal to trigger a side mirror camera.

  3. Connect each RCA analog video cable to the VIDEO IN connectors on the back of the stereo, as shown.

    Line drawing of camera inputs with callouts

    Callout number one

    Front camera

    Callout number two

    Left camera

    Callout number three

    Right camera

    Callout number four

    Backup camera

  4. Connect the analog high signal wire for the backup camera to the pink REVERSE wire of the power and speaker wiring harness (Power and Speaker Wiring Harness).
  5. Connect the analog high signal wire for each of the other cameras to the appropriate camera detect wire of the analog signal detect harness (Analog Signal Detect Wiring Harness).
    NOTE: If you do not want to trigger a camera automatically, you should leave that camera detect wire disconnected.

    Harness wire color

    Camera

    Blue

    Left camera

    Orange

    Right camera

    Brown

    Front camera

Copyright © Garmin. All rights reserved.GUID-811CF923-05C5-4722-B874-97869503F42E v2